Aluprof R Serie Handbuch Seite 9

7. PROGRAMMING THE DIRECTION OF MOVEMENT
I
2 X
Press the SET button (which is on the
head of the motor) for 6 seconds.
II
2 X
Turn on the power, 2 short beep will
be heard immediately (2xBIP).
8. FUNCTION WITH SUPPORT OR WITHOUT SUPPORT
1 X
Press the „P2" button and you will hear
an acoustic signal (x1 BIP).
9. EREASING THE MEMORY OF THE MOTOR
1 X
Press the „P2" button and you will hear
an acoustic signal (x1 BIP).
To clean up emiter means deleting all the memory of emiter in the motor receivers.
- 9 -
4
PROGRAMING MANUAL FOR DM MOTORS, SERIES DM R
OK
Hold the button till the tubular motor
will make three short beep (3x BIP).
This means that the directions of the
movement have been changed.
2 X
In an interval of about two seconds,
press the „P2" button twice and you
will hear an acoustic signal (x2 BIP).
1 X
Press the „UP" button and you will
hear an acoustic signal (x1 BIP).
1 X
Press the „STOP" button and you will
hear an acoustic signal (x1 BIP).
1 X
Press the „DOWN" button and you will
hear an acoustic signal (x1 BIP).
Press the „P2" button
Press the „P2" button
We reserve the right to any technical change. Valid on 2020.01.27
OK
After correct programming the
tubular motor will make 6 short beeps
(6xBIP) and it is ready to regular
using.
3 X
After successful setup the radio receiver
will beep (x3 BIP) and move up-down.
The device will switch into operation
mode without support, repeat the
programming sequence to return to the
operation mode with support.
3 X
After successful setup the radio
receiver will beep (x3 BIP) and move
up-down.
2020.02.17