Aluprof R Serie Handbuch Seite 8

4. PROGRAMMING THE FIRST TRANSMITTER.
I
2 X
Press the SET button (on tubular
motor's head) one time, 2 short beep
will be heard immediately (2xBIP).
II
Turn on the power, 2 short beep will
be heard immediately (2xBIP).
This function deletes previously saved transmitters from the motors memory
5. SETTING THE LIMIT SWICHES
6. ADDING ANOTHER TRANSMITTER.
2 X
Press the button „P2" twice of the
already programmed transmitter and
you will hear an acoustic signal (x2 BIP).
- 8 -
We reserve the right to any technical change. Valid on 2020.01.27
PROGRAMING MANUAL FOR DM MOTORS, SERIES DM R
In an interval of about two seconds,
press the „P2" button twice and you
will hear an acoustic signal (x2 BIP).
2 X
In an interval of about two seconds,
press the „P2" button twice and you
will hear an acoustic signal (x2 BIP).
1. Start the opening mode of the shutter until it stops in the requested position (if the roller shutter is still opening and the motor
2. Regulate the knob (marked ⇧ ) in the (+) direction set the requested position of the shutter.
is still working it should be stopped and proceed to step 3).
3. Raise the shutter and regulate the knob in the (-) direction and repeat the procedure if the requested position is crossed.
1. Start the closing mode of the shutter until it stops in the requested position (if the roller shutter is fully closed and the motor
2. Regulate the knob (marked ⇩ ) in the (+) direction set the requested position of the shutter.
is still working, it should be stopped and proceed to step 3).
3. Raise the shutter and regulate the knob in the (-) direction and repeat the procedure if the requested position is crossed.
Press the "P2" button of the new
transmitter.
2 X
Press the „UP" button and you will
hear an acoustic signal (x1 BIP).
2 X
Press the „UP" button and you will hear
an acoustic signal (x1 BIP).
OK
After successful setup the radio
receiver will beep (x5 BIP).
1 X
OK
After correct programming the
tubular motor will make 6 short beeps
(6xBIP) and it is ready to regular
1 X
OK
After correct programming the
tubular motor will make 6 short beeps
(6xBIP) and it is ready to regular
using.
using.
2020.02.17
3