Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
In general, lighting effects should not be connected to dimming-packs.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
DMX-512 connection / connection between fixtures
The two 3-pin XLR connectors are for the DMX system. The device needs two channels to control it.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
Caution: The Gigastrobe cannot be controlled via a 10V signal
The occupation of the Dip-switches is as follows:
Caution: This strobe can only be addressed on the channels 1-30 and 257-288.
OPERATION
Caution: Before connecting the strobe with the mains, the Intensity-control and the Flash Rate-control have
to be set to minimum position.
14
Werbung
Inhaltsverzeichnis
