remis REMIcare Van Ford Custom Nugget Montageanleitung Seite 17

A13
A13-2
A14
A18
A15.1
A15.2
A13:
Close the insect protection door and mark the position of the
drill hole in the vehicle panel.
Please note that the guide profile must not have more than
2 mm of air to the head piece.
Bring the handle bar into rest position and pre-drill the hole
with a 2 mm drill bit.
A14:
Screw the upper guide rail in place at the marked position
with the countersunk screws 3.0x16.
A15.1+A15.2:
Pre-drill the cover with a 2.5 mm drill bit in the upper as
shown and lower area shown and screw it in place with the
3.5 x 25 pan-head screws.
US/GB
17