Control Lock - Remco Rmt-Bl-01-Kit-Ef-Cha Montageanleitung

Control lock

1. Press and hold the M button. The display will show S- then it will show the
current height setting of the desk and finally, it will change to LOC.
2. To unlock: Press and hold the "M" button until the display changes from LOC to
the current height
Switching measurement units
1. Press and hold the down button until your Bike Lift reaches its lowest position.
Release.
2. Press and hold the down button until the display reads RST (reset). Release.
3. Press the 2 button until the display shows 10.3 (centimeters) or 10.4 (inches),
stop when you've reached your preferred selection. Wait until the display goes
back to "RST".
4. Press and hold the down button again, this time until your Bike Lift lowers a bit,
then raises a bit, and finally stops. Let go of the down button. Your preferred units
should now be the default.
Constant-Touch & One-Touch
One-Touch requires only a single touch of a button to move the Bike Lift to a
memory preset. Constant-Touch requires you to hold the button to move the Bike
Lift to a memory preset.
1. Press and hold the down button until your Bike Lift reaches its lowest position.
Release.
2. Press and hold the down button until the display reads RST (reset). Release.
3. Press the "1" button until display shows "10.1" (One-Touch) or "10.2" (Constant-
Touch) stop when you've reached your preferred selection. Wait until the display
goes back to "RST".
4. Press and hold the down button again, this time until your Bike Lift lowers a bit,
then raises a bit, and finally stops. Let go of the down button. Your preferred
memory preset operation should now be the default.
19