Remco RMT-BL-01-KIT-EF-CHA Montageanleitung Seite 18

Step 6 - Calibration
Calibration and Reset procedure
Your Bike Lift needs to be calibrated after assembly. The calibration process
should also be the first step in troubleshooting should any issues arise during
use. To calibrate your bike lift:
1. Press and hold the down button until your Bike Lift reaches its lowest position.
Release.
2. Press and hold the down button until the display reads RST (reset). Release.
3. Press and hold the down button again, this time, until your Bike Lift lowers a bit,
then raises a bit, and finally stops. Let go of the down button.
4. Your Bike Lift is ready to work.
Memory presets
Your Bike Lift comes with Preset 1 set to the lowest possible height and Preset 3 set
to the maximum height. These can be changed to reflect your preferences. To
change a preset move the Bike Lift to your desired height. Then, press the M button
followed by one of the three preset buttons. From now on pressing that button will
return your Bike Lift to the saved height.
1 2 3 M
18