Electrical Connection; Air Line Condition; Safety Precaution - Circor Rtk Sr 1000 L Installations- Und Betriebs-Anleitung

Einbau- und Betriebsanleitung
Installation and Operating instructions
Instructions de montage et de service
Inside the positioner the clamping spring mechanism must be besieged (see figure 12).
7

Electrical connection

7.1

Air line condition

5. Open the front cover.
6. Locate the poles and connect accordingly. Be sure all screws are tightened (see figure 11).
7. Close the cover.
8. Only feed the cable into the housing with the appropriate cable fitting and secure.

Safety precaution

SR 1000 L has been developed according to the mandatory guidelines of inherently safe systems. However, inherently sable systems can be
damage by electric energies of other electronics. Please read the following to prevent any system damage:
•
Isolate one inherently safe circuit from another.
•
Construct a device to minimise friction.
•
If possible, reduce the use of induction and capacity.
When application allows, set the devices to a value below the maximum.
Figure 12- spring opens
Figure 13
6139-8010
07/2018