RADICAL R-C10AD2 Installationsanleitung Für Masten Seite 10

[Hier eingeben]
6. Connect one of the main connection
cables (No. 11/12) of the Radical device
(No. 1) to the Quadlock/ISO connector
of the car and close its locking
mechanism. Following this, connect the
CAN bus interface (No. 14) to the main
connection cable. Connect all the cables
to the Radical device (No. 1) those
previously run in the radio slot, and the
original antenna cables.
7. Before installing the Radical device
(No. 1) remove the two transport
securing screws.
8. Neatly arrange the wires to the side,
making room for the Radical device.
Carefully slide it into the radio slot.
Push back the R-C10AD2 until you
hear the clicking sound of the
latching mechanism.
The installation of your R-C10AD2 is
now complete.