Baxall DVS24 Installations- Und Betriebsanweisungen Seite 7

Operating Your DVS
To select a camera on the MAIN monitor ... simply press a
numbered key.
To select a camera on the SPOT monitor ... press and hold the
SPOT key and press a numbered key.
To start the sequence on the MAIN monitor ... press and release
<AUTO>.
To stop the sequence on the MAIN monitor ... press and release
a numbered key.
To start the sequence on the SPOT monitor ... press and hold
<SPOT> press and release <AUTO>.
To stop the sequence on the SPOT monitor ... press and hold
<SPOT> press and release a numbered key.
To set a dwell-time on the MAIN monitor ... select the camera
you want to change, press and hold <AUTO>. The dwell-time for
the current camera is displayed on the main monitor in seconds.
Use <1> to decrease the dwell-time and <2> to increase it, when
you are satisfied release <AUTO>.
Repeat this for all the cameras you need to change.
To set the global dwell-time on the SPOT monitor ... Press and
hold <SPOT> and <AUTO>. The dwell-time is displayed on the
main monitor in seconds.
Use <1> to decrease and <2> to increase the global dwell-time,
when you are satisfied release <AUTO> then <SPOT>.
NOTE: Switching off the power does not erase any settings.
To position the caption on the screen ... Remove the power plug
from the back of your DVS2. Press and hold <AUTO> and
re-insert the power plug.
Keep <AUTO> held throughout this procedure.
English
Page 6