Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Connecting your DVS2
Make all the video connections using 75ohm coaxial cable with
BNC connectors on each end.
When you are ready to connect your DVS2, refer to figure 2 and
follow the instructions given below:-
Connect a cable from the connector labelled MAIN to your monitor
»
or VCR.
Connect cables from the cameras to the numbered video-input
»
BNCs.
Plug the jack-plug from the 12V DC power supply into the
»
jack-socket marked 12V DC.
Plug the power supply into a suitable mains power outlet.
»
Switch on the cameras, monitor and DVS2 (at the mains power
»
outlet).
8
7
Note: We have provided a supplementary earth terminal on the
rear panel, please ask Baxall Technical Support if you need
further information.
Switching On the Power
When you switch the power on, your DVS2 may start by
displaying a sequence or a single camera. If it cannot find any
camera inputs then it scans rapidly through the camera selection
LEDs but does not display a picture.
English
6
5
4
Figure 2. Rear Panel Connections
MAIN
3
2
1
ALARM 12V
SPOT
Earth Terminal
Page 5
DC
Werbung
Inhaltsverzeichnis
