Baxall DVS24 Installations- Und Betriebsanweisungen Seite 5

The DVS2
Your DVS2 takes either 4 or 8 camera inputs which it switches to
two monitors. You can select cameras by pressing the relevant
numbered key. There is also an AUTO key which starts an
automatic sequence on the current monitor. This sequence displays
all the cameras in numerical order and automatically skips any
unused inputs.
You can sequence both monitors at the same time, with each
displaying its own sequence. The time spent on each camera in a
sequence is called the dwell-time, this can be varied from 1 to 60
seconds. On the main monitor you can change the dwell-time for
each camera separately, however on the spot monitor the same
dwell-time applies to all cameras in the sequence. This is called a
global dwell time.
You can also link the DVS28 to 8 alarm inputs (the DVS24 to 4)
by using it with the AL8. The available response options are
described later in these instructions.
Figure 1. A Typical switcher Arrangement (DVS28)
English
Page 4