RUSTA BERGEN Handbuch Seite 5

INTRODUCTION
• Before using your new heater, please carefully read through the following
instructions. Keep this booklet in a safe place for future reference.
• After removing the packaging, make sure that the appliance is in good condition.
• Do not allow children to play with the packaging materials, as there is risk of
suffocation.
BEFORE USE – LEG ASSEMBLY
Warning: Do not use this heater unless the legs are securely attached.
ASSEMBLY
1. Before assembling the legs, place the heater upside down on a stable, scratch-free
surface.
2. Hold one leg against the bottom of the heater
so that the holes on the legs fit into the holes on
the heater.
3. Attach the leg to the heater using the screw
provided.
4. Repeat the above steps to attach the other legs.
OPERATION
1. Keep the unit on a flat, stable surface away from obstacles. For safety reasons, keep
all objects at least 150 cm from the front, and 50 cm from the sides and rear of the
appliance.
2. Connect the appliance to a power socket of the same rating as specified on the unit's
rating label (or see technical specifications).
3. Set the main power switch to the on (I) position.
4. Press the power button to turn on the unit. The flame-simulation lighting turns on
at maximum brightness. The display screen shows the default temperature of 25°C.
The display screen flashes. Press the UP or DOWN button to adjust the temperature.
The adjustable temperature range is 15-36°C. Press the UP or DOWN button once to
increase or reduce the temperature by 1°C. When the room temperature is higher
than the default temperature of 36°C, the heating functions cannot come on. When
the room temperature is lower than the default temperature of 36°C, the heating
functions can come on.
5. Press the dimmer button repeatedly to reduce the brightness and flame-simulation.
There are five dimmer button settings.
6. Press the heat button to turn on the heating function. There are two heat settings:
• Press once for high heat (1800W). The high heating indicator lights up.
• Press again for low heat (900W). The low heating indicator lights up.
Press the heat button a third time to turn off the heating function.
5