thomann t.racks box pro Achat Amprack MK II Schnellstartanleitung Seite 2

Dear customer,
Thank you for purchasing this amp rack.
The DSP in this rack has been pre-programmed for various the box pro Achat loudspeaker systems.
To select the desired preset, proceed as follows:
1. press the PRESET button (2)
➔ The "Load Preset" menu opens.
2. use the rotary control (3) to select the corresponding preset. Press the rotary control to confirm.
The settings are loaded.
➔
The connection panel is prepared for four-pin system wiring.
To use the connections for the Achat system wiring, turn the cover of the connection panel so that the cut-outs
are in a vertical position.
These connections enable simple cabling with four-core cables, as the tops receive their signal on wires 1+/ 1-
and connect wires 2+/ 2- through; the bass is connected to wires 2+/2- and connects wires 1+/ 1- through. The
order in which the speakers are wired is not important. However, note the minimum load impedance of the
amplifiers.
A Y-split cable (article number 459796) is recommended for conventional wiring via the connection panel. The
connection sockets on the connection panel are wired as follows: The signals of the t.amp E-1200 mid/high power
amplifier are on 1+/1-, the signals of the t.amp E-1500 bass power amplifier are on 2+/2-.
If you have any questions, please feel free to contact our sound department team.
You can reach us by phone on +49 9546 9223-35, by email at pa@thomann.de or via live chat.
We hope you enjoy your new PA!
Your Thomann Team