Satellite Found, But Not All Channels; Error During Software Update; Error Messages: Calibration Failed, Error Azimuth Adjustment, Error Elevation Adjustment; No Lnb Signal - Travel Vision R7 80 Benutzerhandbuch

7.3

Satellite found, but not all channels

Check if your subscription or smart cart is still valid.
7.4

Error during software update:

Repeat the software update procedure
7.5 Error during software update:
Check if the software has been correctly stored on the USB flash drive.
7.6 Error during software update:
Insert the USB flash drive once more.
7.7

Error messages: calibration failed, error azimuth adjustment, error elevation adjustment

ERROR DURING
CALIBRATING
Check that there are no obstructions which hinder the rotation or alignment of the dish. Remove the
control module from the antenna unit and reinsert it again.
7.8

No LNB signal:

Check if the F-connector to the LNB is connected and tightened.
Check if the LNB cable is damaged.
Contact your dealer.
7.9

Error E: OXBAFF

Fault in motor electronics. The control module requires repair, please contact your dealer.
E:ERROR DURING
UPGRADE
E:FIRMWARE NOT
FOUND
E:USB DISK NOT
FOUND
ERROR AZIMUTH
ADJUSTMENT
NO LNB SIGNAL
E: OXBAFF
SEE MANUAL
ERROR ELEVATION
ADJUSTMENT
page 17