Removing The Control Module - Travel Vision R7 80 Benutzerhandbuch

When no GPS signal is found, the system will stop searching and displays Dish holder on 2, and press start for
second search. Finding the satellite will take longer (or satellite will be not found) because the optimal position for
the LNB and bracket is not provided
2. During searching for the satellite with no GPS location, the system could suddenly stop searching and
show the following message:
This indicates that the system has found the GPS location and that the position of the LNB and bracket
has to be adjusted as shown on the display. If you do not adjust the LNB and bracket position, the
system may not receive a satellite signal.
Turn the LNB and bracket to the correct position and press the Start button (1) the system will resume
searching.
3. When the system finds a satellite with the correct characteristics, the dish will stop rotating. But if the
system concludes it has not found the selected satellite after the internal check, the following message
will be shown:
The system will automatically resume searching for the selected satellite.
3.7

Removing the control module

A release pin is located on the bottom of the control module. Press this release pin to remove the control module.
NO GPS FOUND
DISH IN POS. 1
AND PRESS START
ROTATE LNB --
AND PRESS START
ASTRA 1 19.2 °
INCORRECT SAT.
The control module is unlocked after the release pen is pressed.
Carefully remove the control module by pulling it to the right. Do this
gently to ensure that the current alignment of the dish is not altered.
page 13