Travel Vision R7 80 Benutzerhandbuch Seite 11

(Note: The mentioned LNB position is just an example)
Additionally the correct position of LNB will be indicated after GPS location has been determined.
After you have correctly positioned the LNB, press the Start button (1)
When the GPS location is not yet found, the GPS position will be located with countdown from 4 minutes.
Once the GPS position has been found, read off the corresponding bracket adjustment and put the bracket in the
right position.
(Note: The mentioned Dish position is just an example.)
Additionally the correct position of bracket will be indicated.
After you have positioned the bracket, press the Start button (1)
The system will start the calibration within 5 seconds and search its vertical and horizontal reference points. The
following messages will be presented on the display:
After this startup phase, the system will automatically begin its search for the selected satellite. For example:
WAIT FOR GPS
.. min...sec
DISH IN POS. 1
AND PRESS START
Bracket in position 1 or 2
CALIBRATING
PLEASE WAIT
CALIBRATING
ELEVATION
CALIBRATING
AZIMUTH
page 11