Water Circuit Hookup; Connection To The Drain Line; Rinse Aid And Detergent; Salt Filling (When Built In Softener) - ACKERMANN BA U 530 Bedienungsanleitung

UK
•
The water supply, temperature and pressure must be compatible with the ratings on the
machine's nameplate.
•
If the hardness of the water is greater than 6°dH, we recommend using an internal water softener
(available on request). If the hardness of the water is greater than 20°dH, install and external water
softener upline of the solenoid valve.
•
If the water has a very high residual concentration of high conductivity minerals, we recommend
installing a demineralisation system.
Free drain
Max.
1 m
With pump (available on request)
•
The rinse aid and detergent are dispensed by the machine's integral dispenser.
•
The dose is set by the installer and he also calibrates the dispensers themselves.
•
Before calibrating them, fill the dispenser supply tubes with their respective product (dishwashers
with electronic device see parameter dN and bN in menue 12).
•
The units are calibrated with the adjuster screws, or directly with the control panel (see parameters
dt and bL in menue 12).
•
The level of fluid in the container must be sufficient for priming; do not allow it to drain completely
or top it up with corrosive or impure product.
For the first filling we recommend to give first some water in the salt container. Then add salt.
Page 4 of 12
INSTRUCTION MANUAL FOR DISHWASHERS
The appliance must be connected to its water supply with a flexible hose. A
shut off valve (cock) must be installed between the water supply line and
the appliance's solenoid valve. The cock must be close to the appliance.
•
The drain line must consist of a free drain sump with siphon suited to
the flow capacity of the drain hose supplied with the appliance. The
hose must be able to reach the sump without stretching, restriction,
folding, crushing, pressing or forcing in any way.
•
The tub drains under gravity, so the drain sump must be lower than the
machine's base.
•
if the drain is not lower than the base of the appliance, you can use the
version with drain pump (available on request).
•
In this case, the drain connection may be no higher than 1 m.
•
Always check that the drain works properly and is not blocked.
•
Any other solution must be approved by the manufacturer in advance.

2.4 Water circuit hookup

2.5 Connection to the drain line

2.6 Rinse aid and detergent

2.7 Salt filling (when built in softener)