Scott BHELL2401 Benutzerhandbuch Seite 4

I INTRODUCTION
BATTERY T YPE, CAPACIT Y AND NOMINAL VOLTAGE
BHELL2401 Lithium polymer (Li-Po), 3.7 V , 100 m Ah, 0.37 W h
II QUICK START GUIDE
BAT TERY CHARGING We duly recommend to charge the
light before its first use. To optimize its charging time, please
ensure that USB port or charger carries at least 1A. Estimated
charging time : 2h00. Charging the device with a PC may lead
to longer charging times or not charging. During the charge,
a red LED is on / s teady in the power button, once the battery
reaches the maximum charge, the LED turns OFF.
INSTALL ATION Press the sides of light and introduce it into
the dedicated space in back side of the helmet until you feel
and hear a "click". For removal of the light, press the two sides
of the light and carefully pull the light out of the helmet.
USE OF THE LIGHT To turn ON the light, press the pow-
er button for more than 1 second, use the same action to
turn it OFF.
BATTERY LEVEL Battery level is shown when the power button is pressed during less than 1 sec-
ond while the light is OFF. A small LED in the power button shows the battery level of the light with
the following pattern :
0-20% Flash red color
RUNNING TIMES AND MODES The different modes can be selected clicking the power button.
Mode
1 Steady
2 Flashing
3 Slow flashing
| 8 ENGLISH
ENGLISH
LIG HT S YSTEM
20-40% Steady red color 40-100% Steady green color
Runtime
~ 1h 30min
~ 3h 30min
~ 3h 30min