Warnings And Safety - Huffy In-Line Bedienungsanleitung

Warnings and Safety

If you have any questions regarding the operation of this product, please refer to this
owners manual or call Customer Service - see Consumer Service contact info.
ALWAYS WEAR
YOUR HELMET
WHEN RIDING THIS
PRODUCT!
Always read the user manual that comes with your helmet to make sure it is fi tted and
attached properly to the wearer's head according to the fi tting instructions described in the
user manual .
Torque Table - Recommended Torque:
Use of a torque wrench is recommended .
Recommended torque for each fastener is
listed below . In addition to tightening to
the recommended torque, please ensure
the parts of the product are suffi ciently
tightened by performing the functional tests
(in the component assembly sections of the
Recommended Torque for clean, dry threads:
Fastener Size
4 mm ( .157 in)
5 mm ( .196 in)
6 mm ( .236 in)
7 mm ( .275 in)
8 mm ( .314 in)
10 mm ( .393 in)
6
Torque (N•m / ft-lb)
4 .2 N•m (3 .1 ft-lbs)
6 .8 N•m (5 ft-lbs)
9 .5 N•m (7 ft-lb)
16 .3 N•m (12 ft-lbs)
23 N•m (17 ft-lbs)
44 .7 N•m (33 ft-lbs)
owner's manual) on each component as it is
tightened .
NOTE:
Please check that all fasteners on the
product are torqued according to the table
below:
How to Measure:
Screw or bolt size is determined by the
width at the THREADS as shown .