RONDELL RDE-1051 Betriebsanweisung Seite 9

THERMOPOT RDE-1051
An electric thermopot is intended for boiling water and maintain-
ing the required temperature of water.
DESCRIPTION
1. Drip tray
2. Water level scale
3. Display
4. Spout for pouring water
5. Control panel
6. Lid opening button
7. Steam release openings
8. Upper lid
9. Body
10. Power cord connector
11. Power cord
Control panel
12. Cool mode button «Fast cooling»
13. Water type selection/on/off button «Water type/On/Off»
14. Temperature selection button «Т°С selection»
15. Water dispensing unlock button «Unlock»
16. Water supply button «Dispense»
17. Temperature indication
18. Fast cooling mode indicator
19. Tap water mode indicator
20. Water dispensing indicator
21. Drinking water mode indicator
22. Keep warm mode indicator
23. Unlocked water dispensing indicator
ATTENTION!
For additional protection it is reasonable to install a residual cur-
rent device (RCD) with nominal operation current not exceeding
30 mA, to install RCD, contact a specialist.
SAFETY MEASURES
•
Before using the unit, read this manual carefully and keep it
for future reference.
•
Use the unit for its intended purpose only, as specified in this
manual.
•
Mishandling the unit can lead to its breakage and cause harm
to the user or damage to his/her property.
•
Make sure that the operating voltage of the unit corresponds
to the voltage of your mains.
•
The power cord is equipped with a "euro plug"; plug it into the
socket with reliable grounding contact.
•
To avoid fire, do not use adapters for plugging the unit in.
•
Do not use the unit in bathrooms. Do not use it near swimming
pools or other containers filled with water.
•
Do not use the unit in places where aerosols are sprayed or
highly flammable liquids are used.
•
Do not use the unit outdoors.
•
Do not connect or disconnect the power cord with wet hands,
this may cause electric shock or injuries.
•
When unplugging the unit, always pull the plug but not the
cord.
•
Never leave the operating unit unattended.
•
Do not switch the thermopot on if it is empty.
•
Do not drop or tilt the unit.
•
Be careful when using the thermopot to avoid getting water on
the electrical connector.
•
Use the thermopot only for water boiling; it is prohibited to heat
or boil other liquids in it.
•
Make sure that the water level in the thermopot is not above
the mark «FULL».
•
Place the thermopot on a flat dry and stable surface; do not
place the thermopot on the edge of the table.
•
Do not place the thermopot next to the walls or close to the
kitchen furniture.
•
Place the thermopot keeping at least 20 cm gap between the
thermopot body and the wall and at least 30 cm gap above
the thermopot.
•
Do not use the unit near heat sources or open fire.
•
Do not let the power cord hang from the edge of the table and
make sure it does not touch hot or sharp edges of furniture.
•
Do not open the lid and do not pour water out during boil-
ing. Be careful when you open the lid right after water boiling.
•
Do not rotate the unit during water pouring.
•
Do not apply excessive effort when closing the lid. When using
the thermopot, make sure that the lid is closed tightly.
•
Keep your hands away and do not bend over the steam release
openings, it may cause burns. Do not block the steam release
opening with any objects.
•
Do not touch hot surfaces of the thermopot.
•
Be careful while carrying the thermopot filled with boiling
water.
•
Provide that no water gets on the display or touch buttons.
•
Be careful, avoid getting liquid on the electric connectors
during cleaning or filling the thermopot with water and pour-
ing the water out.
•
Do not carry the thermopot holding it by the lid opening button.
•
Be careful when pouring out hot water.
•
Be careful, the heating element surface remains hot for some
time after the use!
•
To avoid risk of electric shock, do not immerse the thermo-
pot, the power cord and the power plug of the unit into water
or other liquids.
•
Unplug the unit, if you are not using it or before cleaning.
9
ENGLISH