Timer Function; Replace The Battery - Songmics Vasagle Rmb103 Montageanleitung

EN
Instructions:
1. Before using the remote control for the first time, please remove the plastic sheet from the bottom of the remote control.
2. During use, if the controller works normally but the remote control does not, it is necessary to pair the remote control:
Unplug the power cord for over 3 seconds and then plug it in again. Within 7 seconds of powering up, press and hold the power
button on the remote control for 3 seconds. The light strip will flash white 3 times to indicate that the remote control has been paired.
3. If ≥ 2 of these products are purchased, one remote control can control 2 or more products by default.
① If you want a remote control to control 2 or more products (to restore the default state), please unpair it first:
Unplug the power cords of all products that need to be unpaired, wait for over 3 seconds, and then plug them back in.
Within 7 seconds of powering up, press and hold the white button for 3 seconds.
The light strip will flash 3 times and emit a white light to indicate that the remote control is unpaired.
② If you want a remote control to control only one product (individually paired), follow the steps below:
Unplug the power cords of all products that need to be paired, wait for over 3 seconds, and then plug them back in.
Within 7 seconds of powering up, press and hold the power button on the remote control for 3 seconds.
The light strip will flash white 3 times to indicate that the remote control has been paired.
Note: When pairing, only power on the product you want to pair and keep all other products powered off.
For example, when pairing product A, power on A and keep B powered off; when pairing product B, power on B and keep A powered
off.

Timer Function:

For safety, this product's light strip has an automatic shut-off function.
Cancel and set the timing:
① Press the DEMO, Red, and SPEED- buttons in sequence to cancel the timer setting. The green light will flash to indicate that the
timer cancellation was successful.
② Press the DEMO, Red, and SPEED+ buttons in sequence to set a 1-hour timer. The light will automatically turn off when the timer
ends. The red light will flash to indicate that the timer has been successfully set.
The red indicator light of the remote control is always on:
Perhaps one of the buttons is stuck. Please press all of the buttons firmly to see if they spring back.

Replace the Battery:

Place the new battery into the compartment in the correct orientation for the positive and negative terminals. Be careful not to
reverse them. See the figure below for reference:
22
Remote Control Instructions
MODE+/MODE-: Switch from static color to dynamic mode, or switch between dynamic modes (breathing mode,
strobe mode, color changing mode).
MODE+: Next mode.
MODE-: Previous mode.
DEMO: Cycles through each color.
SPEED+/SPEED-: Adjust speed.
BRIGHT+/BRIGHT-: Adjust brightness.
COLOR+/COLOR-: Change color. 25 colors in total.