Using The Microphone; Recording Function; Led Lighting - Fontastic Rokka Bedienungsanleitung

GB
Note: The microphone settings can only be changed when the microphone is connected.

Using the microphone

Plug the jack plug of the microphone cable into the microphone input (5) of the Rokka. Turn on the microphone by sliding
the on/off switch to the ON position. Singing or speech into the microphone will now be output via the speaker.
Press the MODE button (13) on the speaker to adjust settings such as treble, bass, volume, and echo. Use the volume
control (6) to adjust the settings in the corresponding menu.

Recording function

To record with the microphone, a storage device must be inserted into the USB or TF card slot to store the recordings.
Press the record button (14) to start recording. Press the record button (14) again to stop recording.
You can then listen to the recording. The start/stop button
Track buttons jump between the last recordings. Press the MODE button (13) to exit recording mode.
Note: Your recordings are stored on your storage medium in a new folder called "JL_REC".
Note: If you change modes during recording, the recording will be stopped.

LED lighting

Press the LED button (10) briefly to turn on the LED effect lighting.
Press the LED button again briefly to change the lighting mode. There are eight different modes.
Press and hold the LED button to turn off the LED effect lighting.
TWS
(wireless connection of two Fontastic Rokka speakers)
TWS only works in conjunction with Bluetooth
speaker.
Turn on both speakers and first connect one of the speakers to your Bluetooth
Then press the start/stop button
the two speakers are connected, audio from Bluetooth
Remote
Note: Before first use: The button cell battery (type CR2032) is pre-installed in the remote. Pull the insulating strip
out of the button cell battery holder. When using the remote control, please point it vertically at the speaker from
above.
Replacing the battery:
- Loosen the screw on the battery compartment cover with a Phillips screwdriver (Fig. 1).
- Push the lock to the right and pull out the battery compartment (Fig. 2).
- Remove the empty button cell battery from the holder in the battery compartment and insert a new CR 2025 button cell
battery. Ensure that the polarity is correct (Fig. 3).
- Push the battery compartment back into the remote control until it clicks into place. Reattach the screw using a Phillips
screwdriver.
Fig.1
Transport handle
The pull-out transport handle and casters make the trolley speaker mobile.
To pull out the handle, press the release button on the underside of the handle and pull
the handle upwards.
Follow the steps in reverse order to retract the handle into the housing.
7
pauses the recording. The Previous Track
. USB, TF, and microphone are only output on the connected
®
on the paired device once. The two TWS speakers will connect to each other. Once
devices can be played through both speakers.
®
Fig.3
device as described under "Pairing".
®
AFig.3
and Next