After power loss or recharging
1. Re-pairing is not necessary after turning off or recharging the lamp.
2. If pairing with a new remote is needed, hold the lamp button until it starts flashing.
3. Pair the lamp with a different remote or group by repeating the pairing steps.
Lamp Operation and Charging
1. There is a main switch in the lamp. Rotate to open the lamp cover and push the main
switch ON with dry fingers, then the lamp can be operated by touch or remote controller
in your daily use. If you do not use the lamp for long time, just keep the main switch OFF.
2. While charging, the lamp will emit a red light, which turns green when fully charged.
Charging takes approximately 8 hours.
3. Operating time: ranges from 12 to 72 hours, depending on the selected brightness level.
4. The lamp can be used while charging (except during remote pairing mode). Charging
should only be performed indoors
5. Use a charger with output of DC 5V max. 1A. Using a higher output may cause the lamp
to enter self-protection mode with flashing light and won´t charge.
RIGHT OF COMPLAINT
By law the product must be returned to the place of purchase along with the original
receipt in the event of a complaint. The user is liable for any damage to the product that
is caused by not using the product for its intended purpose or by not following this user
manual correctly. The right of complaint will not apply in these instances.
ENVIRONMENT AND RECYCLING
When the product is used up, leave it for recycling according to local
waste disposal regulations. Note that the product must not be disposed
o
of with normal household waste.
4
Main switch
USB
Type-C