Upgrade TITANIUM PRO Gebrauchsanweisung Und Garantie Seite 11

Once the appliance has reached the set temperature,
the display will start flashing and the appliance will be
ready to use.
6. When you have finished, turn off the appliance by
holding down the power button for 3 seconds and
disconnect the power cable from the wall socket.
COLOUR DISPLAY
Effortless 3 Colour Reading Display
°C
230 –
–
–
200 –
–
–
170 –
–
–
140 –
–
–
110 –
–
–
80 –
HAIR: damaged thin normal coarse
ENERGY-SAVING FUNCTION
The appliance switches off automatically 60 minutes after
the start of use. In this case, switch the appliance on again.
The working settings used will be reset automatically.
Problem
The display does not light up and/or
the appliance does not heat up.
The cord or the appliance makes
abnormal noises or sparks.
The display does not stop flashing.
Appliance has switched off after 60
minutes after switching on.
If the problem is not solved, contact your dealer or Labor Pro Technical Service Centre.
BLUE:
from 60°C to 155°C
GREEN:
from 160°C to 185°C
RED:
from 190°C to 230°C
wavy thick + curly
TROUBLESHOOTING
Possible reason
Fault in the circuit board or heating
The appliance or the power cord is
The curling iron is heating up but
does not reach the set temperature.
The energy-saving function has
been activated.
SELF-DIAGNOSIS FUNCTION
The appliance has a self-diagnosis system that alerts
the user to problems with the heating elements or
the electronic circuit. If necessary, the heating of the
appliance stops and the display shows "Err" Disconnect
the power cable from the wall socket and contact your
dealer or the Labor Technical Assistance service..
CLEANING AND GENERAL MAINTENANCE
Before carrying out any cleaning or maintenance,
disconnect the plug from the wall socket and wait until
the appliance has cooled down. For cleaning, use a dry
or slightly damp cloth. Never immerse the appliance in
water or other liquids. Do not use chemical products for
cleaning.
TECHNICAL SUPPORT
For repairs or to purchase spare parts, contact your dealer.
If this is not possible, contact the Labor Pro Assistence
Centre by email at: assistenza@laborprosrl.com
element.
damaged.
Action
Request an inspection or repair at
the place of purchase.
Switch the appliance on again.
EN
11