Maintenance And Service; Maintenance And Cleaning - Bosch GTA 2600 Professional Originalbetriebsanleitung

OBJ_BUCH-843-003.book Page 18 Friday, May 7, 2010 12:39 PM
18 | English
Operation
Working Advice
Do not overload the saw stand. Always observe
the maximum carrying capacity of the saw stand
and the two table extensions.
Always hold the workpiece firmly, especially the
longer and more heavy section. After cutting
through the workpiece, the centre of gravity
may become dislocated in such an unfavourable
manner that the saw stand tips over.
Extending the Saw Stand
(see figures F1 F2)
–
Long workpieces must be underlaid or support-
ed at their free end.
– Place your long workpiece onto the saw table
of the power tool.
– Loosen locking knob 3 and pull the table ex-
tension 2 out to the desired clearance.
– Retighten the locking knobs again.
– Loosen locking knob 7 and adjust the height
of the workpiece support 1 so that the work-
piece rests level.
– Retighten the locking knobs again.
Sawing Workpieces of the Same Length
(see figure G)
The length stop 5 can be used for easily sawing
workpieces to the same length.
– Loosen locking knob 4 and position the
length stop 5 to the desired clearance to the
saw blade of the power tool.
– Retighten the locking knobs again.
1 609 929 W87 | (7.5.10)
Adjusting the Attachment-set Bracket
(see figure H)
After intensive use of the saw stand, the bracket
that locks the attachment set 6 to the saw table
via the the locking knob 8 may possibly require
readjustment.
– Remove the power tool from the attachment
sets.
– Turn the attachment set upside down.
– When the attachment set cannot be locked
to the saw stand despite firmly tightening the
locking knob, screw the adjustment screw 21
in clockwise direction.
When the attachment set does not fit onto
both rails (front and rear) of the saw stand at
the same time, screw the adjustment screw
21 in anticlockwise direction.
– Check the firm and correct seating of the at-
tachment set and repeat the adjustment, if
required.
– Repeat the worksteps with the second at-
tachment set.

Maintenance and Service

Maintenance and Cleaning

If the saw stand should fail despite the care tak-
en in manufacture and testing, repair should be
carried out by an authorised customer services
agent for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit article
number given on the type plate of the saw
stand.
Bosch Power Tools