Typographical Conventions - JUMO mTRON Montageanleitung

1 Introduction

1.3 Typographical conventions

Warning signs
V
Danger
This symbol is used when there may be danger to personnel if the instructions
are disregarded or not followed accurately.
A
Warning
This symbol is used when there may be damage to equipment or data if the
instructions are disregarded or not followed accurately.
Note signs
H
Note
This sign is used if your special attention is drawn to a remark.
v
Reference
This symbol refers to further information in other handbooks, chapters or
sections.
abc 1
Footnote
Footnotes are notes which refer to certain points in the text.
Footnotes consist of two parts: the text marking and the footnote text.
The text markings are arranged as continuous raised numbers.
The footnote text (in a smaller typeface) is placed at the bottom of the page
and starts with a number and a full stop.
h
Action
This symbol is used to describe an action to be performed.
The individual steps are indicated by this asterisk, e.g.
h Switch off the supply
h Pull the connectors off the module
4
The signs of Danger and Warning are used in these Installation Instructions
under the following conditions: