Components; Symbols; Operation; Rechargeable Battery, Capacity And Signal Display - Mafell A18Mbl Originalbetriebsanleitung

dusts can cause allergic reactions and/or
respiratory disorders in the user or persons staying
in the vicinity.
- Certain dusts such as oak or beech dust are
considered as carcinogenic,
conjunction with additives for wood treatment
(chromate, wood
containing material may only be machined by
specialists.
- As far as possible, make use of a dust extraction
system.
- Provide for good ventilation of the workplace.
- It is recommended to wear a respirator mask with
filter class P2.
- Observe the regulations valid in your country for
the materials to be machined.
- Secure the workpiece against shifting, e. g. by
means of fastening devices.
- LED light (14): Do not directly look at the LED
radiation with optical instruments.
4

Components

(Fig. 1 and 2)
(1) Exchangeable chuck
(2) Additional handle
(3) Gear change slide (drilling, impact screw driving
only ASB ...)
(4) Gear change slide - first or second gear
(5) Button – change between max. torque and torque
set at (13)
(6) Sense of rotation selector switch, double sided
(7) Bit holder, double sided
(8) Belt clip, can be used on both sides
(9) Unlocking mechanism rechargeable battery
(10) Button - capacity display
(11) Capacity and signal display
(12) Rechargeable battery
(13) Setting wheel – torque pre-selection, impulse
function
(14) LED light
(15) Switch trigger
especially
preservative). Asbestos-

4.1 Symbols

in
Nm
5

Operation

5.1 Rechargeable battery, capacity and signal
display
(Fig. 3)

Charge the rechargeable battery prior to use.

Recharge the rechargeable battery in case of
loss of power.

The optimum storage temperature is between
10 °C and 30 °C.
5.2 Removing and inserting the rechargeable
battery
(See Fig. 4)

5.3 Sense of rotation, transport lock

Setting the switch-on lock (Fig. 5)

5.4 Selecting the gear speed

(Fig. 6)
Actuate the switch slider (4) only
when the motor is standing still!

5.5 Setting drilling or impact drilling mode

Only for ASB 18 M bl, (Fig. 1)

Set the desired operating method at the gear
change slide (3).
-19-
Movement direction
First gear
Second gear
Screwing
Drilling
Without torque control
Impact drilling
Torque