Renogy RIV2420P2-23S Benutzerhandbuch Seite 33

When the inverter turns on, it is normal to see the fans run for a second and hear a beep.
Avoid powering on the inverter with the load (electronic devices) already switched on. This
may trigger an overload since some electronic devices have an initial high power surge to
start.
When switching off the inverter, turn off the electronic devices first. Although the inverter
is off, the terminal capacitors will still have a charge, so the DC and AC terminals must be
disconnected if altering the circuitry.
█ Wired Remote Control
The Wired Remote Control gives you the opportunity to power on/off the inverter from a distance
(approximately 16.4 ft / 5 m).
Note that the inverter ON/OFF switch should be in the REM position.
Step 1: Connect the Wired Remote Control to the inverter via the Remote Control Connector.
ON
Step 2: Rock the ON/OFF Switch to the REM position, and you can power on/off the inverter via
the Wired Remote Control.
OFF: The inverter is off.
ON: The inverter is on.
RJ12
Ethernet
Cable
ERR
RMS-P2
ON ERR
RMS-P2
EN
-32-