Essentielb RRVP-200 Bedienungsanleitung Seite 9

Switching on/off
Once the device has been plugged in, it will go into
1.
standby mode. Press the on/off button
standby mode and activate it.
Press the on/off button
2.
mode.
Setting the time
To set the time on your radio alarm clock, press and
1.
hold the time/memory setting button
digits start flashing.
<<
Press the button to increase the HOURS digit. You
2.
can hold it down to scroll through the digits.
>>
Press the button to increase the MINUTES digit. You
3.
can hold it down to scroll through the digits.
Once the time has been set, to save the setting, press the
4.
time/memory setting button
Setting the alarm
You can set two different alarms. To do this, follow the
instructions below, making sure the radio is switched off.
16
to exit
again to switch it to standby
until the time
once .
Alarm 1
To set alarm 1, press and hold the Volume - / alarm setting
1.
1 button . The hour digits for alarm 1 start flashing.
<<
Press the button to increase the HOURS digit. You can
2.
hold it down to scroll through the digits.
>>
button to increase the MINUTES digit. You
Press the
3.
can hold it down to scroll through the digits.
Press the Volume - / alarm 1 setting button
4.
or twice to select the type of alarm: buzzer or radio. The
corresponding indicator light (
screen.
�
�
Alarm 2
To set alarm 2, press and hold the Volume + / alarm setting
1.
2 button . The hour digits for alarm 2 start flashing.
<<
Press the button to increase the HOURS digit. You can
2.
hold it down to scroll through the digits.
�
>>
button to increase the MINUTES digit. You
Press the
3.
can hold it down to scroll through the digits.
�
Press the Volume+ / alarm 2 setting button
4.
or twice to select the type of alarm: buzzer or radio. The
corresponding indicator light (
screen.
once
or ) is activated on
�
�
�
�
once
or ) is activated on
�
�
�
�
17