Brief Instructions - Zeiss Victory DC4 Gebrauchshinweise

Victory Camera-Eyepiece DC4

Brief instructions

Charge batteries type LR 06 and insert into the battery compartment (5) of the
camera-eyepiece. Insert the two enclosed batteries type LR 03 into the remote control.
Observe correct polarity according to the symbols on the battery compartment.
Insert the SD-card into the slot (6) underneath the screw cap to the left of the
camera-eyepiece. Insert the card with the label up until it snaps in. Then replace cover.
Mount the camera-eyepiece to your Zeiss Diascope spotting scope just like any normal
eyepiece.
Now adjust the fine double circle in the eyepiece until it seems to be absolutely in focus.
Important: Careful focusing of the double circle is the basic requirement for good pictures.
Please also read the chapter diopter compensation and focus.
Turn on the camera to capture images at the On/Off switch (2).
Select the desired language if not already set:
MENU button, then > SETTINGS
or MENU button, then > EINSTELLUNGEN
Set date and time, if not already set:
MENU button, then > SETTINGS
Align the spotting scope to the desired object and adjust the image in the field of view of
the eyepiece with the help of the focusing feature at the spotting scope.
You will see on the monitor a live preview of the image. Push the OK-button on the remote
control to capture the images.
Important: Make sure that the remote control is always held in the direction of the infrared
sensor on the camera-eyepiece. Otherwise, the remote control cannot transmit commands to
the camera-eyepiece.
The factory-set camera settings provide for an optimum image quality under most conditions.
It is recommended however to read the entire user information so that you are able to utilise
the options available in the various menus, when needed.
> LANGUAGE
> SPRACHE
> DATE/ TIME
39