Register Hand Transmitters - RADEMACHER RP-S4-550N-1 Einbauanleitung Und Bedienungsanleitung

Register hand transmitters

The garage door opener allows you to control the door with a one-button hand
transmitter, as there is a receiver built into the opener housing. In order that the
receiver recognizes the control commands, you must register the hand transmitter.
NOTE!
You can register up to 6 hand transmitters. It is only possible to delete hand
transmitters by carrying out a reset, please refer to page 60.
1. Activate the adjustment mode.
To do this, press the red button and keep it pressed until the internal lamp on
the opener starts to flash.
2. Give the button on the hand transmitter one short press.
Point the hand transmitter in the direction of the opener when doing this.
3. After successfully registering the hand transmitter
the adjustment mode will be automatically ended.
The lamp will no longer flash.
Register additional hand transmitters
Repeat the procedure described above for each additional hand transmitter.
Delete registered hand transmitters again
If you wish to delete hand transmitters that you have registered, you must
carry out a reset, please refer to page 60.
NOTE
All hand transmitters that are registered will be deleted.
One-button hand transmitter,
item no. 4385
RolloPort S4 RolloPort S4
SETZEN
ACHTUNG: Vor Öffnen des Gerätes Netzstecker ziehen!
EN
230V ~ 50 Hz, 200 W, KB. 4 min.
Lampe 230V, max. 40W E14
Zugkraft 550N, - 5° bis + 40°C
Nur für trockene Räume
0811000001
Art.-Nr.: RP-S4-550N-1
63