Operation - Beurer BY 76 Gebrauchsanweisung

– Insert the pole into the designated opening on the bottle grille.
– Turn the pole clockwise until it clicks into place.
– Put the fixing aid as well as the basket for small parts on the pole, until they are resting flat.
4. Plug the mains plug into a socket. The display shows 0. The device is ready for use.
Before using for the first time, let the sterilisation process run once without any parts to be sterilised. For
this, follow the steps in the 'Operation' section.
If you would like to use the device immediately after the empty process, allow it to cool for at
least 20 minutes after draining the residual water. The same applies to numerous consecutive
uses.

7. Operation

1. Clean the parts that are to be sterilised with mild washing up liquid or in the dishwasher. Disassemble
any assembled parts.
2. Measure 120 ml distilled water (alternatively tap water) and pour it into the sterilisation container.
3. Now place the bottles into the bottle stand with the opening pointing downwards and place the teats or
other small parts in the basket for small parts.
4. Place the bottle stand and the basket for small parts into the sterilisation container.
5. Then put the lid on the device.
6. Plug the mains plug into a socket.
The display shows 0. The device is ready for use.
7. Press the switch to start the sterilisation process.
Once the operating temperature has been reached, the remaining sterilisation time is continuously
shown in the display, starting from 7 minutes.
At the end of the process, a signal sounds. You may now switch the steriliser off.
8. After a cooling down period of at least 5 minutes, carefully open the lid and remove the sterilised parts
using the gripping tongs.
9. Shake the parts to remove any excess water.
Remove the mains cable. Drain the residual water and dry the container with a cloth.
11