Using The Appliance; Keep Warm Mode - Remoska Maria R307001 Bedienungsanleitung

EN
use clean tap water only.
• Unwind the required length of the power cord from the bottom of the base. Ensure the
cord is not tangled. Do not pull the cord out to its full length.

Using the Appliance

• Open the kettle lid by pressing the release button.
• Fill the kettle with water to a level between the "MIN" and "MAX" markings on the
inner water gauge. Do not exceed the maximum capacity of 1.7 L to avoid boiling water
splashing.
• Close the lid by pressing it down, then place the kettle on the base and plug it into
a suitable socket. A beep will sound and the LED display will show the internal water
temperature – the kettle is now in standby mode.
• Press the temperature selector and choose the desired temperature. The indicator
will blink for 2 seconds, and the kettle will automatically begin heating. If you press
the "on/off" button without selecting a temperature, the kettle will default to boiling
at 100 °C.
• Once the kettle reaches the selected temperature, a sound signal will be heard and
the kettle will turn off.
• To stop heating, press the "on/off" button again.
• If the kettle is not used for approximately 5 minutes, it will return to standby mode and
the temperature indicator will switch off.
• The kettle does not have a memory function. Once removed from the base, it enters
standby mode. When placed back on the base, the program restarts.

Keep Warm Mode

• Open the kettle lid by pressing the release button.
• Fill the kettle with water to a level between the "MIN" and "MAX" markings on the
inner water gauge. Do not exceed the maximum capacity of 1.7 L to avoid boiling water
splashing.
• Close the lid by pressing it down, then place the kettle on the base and plug it into
a suitable socket. A beep will sound and the LED display will show the internal water
temperature – the kettle is now in standby mode.
• Press and hold the "on/off" button for 2 seconds. Both indicators will appear
and the display will blink for 2 seconds. Then press the temperature selector to choose
the desired temperature – the display will blink again for 2 seconds and the kettle will
automatically begin heating.
• Once the kettle reaches the pre-set temperature, a sound signal will be heard and it
will automatically switch to keep warm mode. By default, the selected temperature will
be maintained for approximately 2 hours.
25