PRIXTON ROMA Bedienungsanleitung Seite 8

Preparation Before Use
• Before using the device for the first time, check if it has battery
power. Tap the button once to see the charge level.
• If you do not get coffee after adding water for extraction, loosen
the locking cup and tighten it again.
• If the ambient temperature is very high, wait at least 5 minutes
between consecutive heating cycles.
• It is recommended to clean the device before first use (see
Cleaning and Maintenance section).
Using Ground Coffee
1. Open the ground coffee compartment lid (7).
2. Pour the ground coffee into the compartment (7) using the
measuring spoon (11) and press it down with the spoon's tamper.
3. Finally, place the compartment into the rotating cup (8).
Using Capsules
1. Remove the accessories. Turn the unit as shown in the image and take out the capsule
compartment (6).
2. Place the coffee capsule into the compartment (6), press it gently, and insert the
compartment into the rotating cup (8).
NOTE: Make sure the rotating cup (8) and the main unit (3) are properly tightened. If not,
extraction may fail or leaks may occur.
Coffee Extraction:
First, press the button (4) once to turn on the coffee maker. The charge level will be displayed
as explained in the previous section on indicator lights. Then:
• With direct hot water: Open the water tank lid (1), pour in hot water, close the lid, and press
the button (4) twice quickly to extract the coffee. To stop extraction, press the button (4)
once.
• With heating: Press and hold the button (4) for 2 seconds. A beep will sound and heating
will begin. Wait 3 to 4 minutes until another beep indicates heating is complete. Then, press
the button (4) twice quickly to extract the coffee. To stop extraction, press the button (4)
once.
8