Troubleshooting Guide - Grohe Blue Fizz Bedienungsanleitung

Problem
✁ ✂ ✄
✠ ✞ ✏ ☛ ✞ ✛ ✆ ✛ ✂ ✑ ✂ ✆ ☎ ✝ ✝ ✛ ✟ ✆ ☎ ✎ ✍ ✖ ☞
Water bottle won't attach.
Water bottle won't release.
✁ ✆ ☎ ✝ ✒ ✞ ✆ ✆ ✍ ☎ ✞ ✓ ☎ ✝ ✠ ✞ ✏ ☛ ✎ ✛ ✝ ✑ ✂ ✘
carbonization.
Water is not fully carbonated.
CO2 bottle leaks after insertion.

Troubleshooting Guide

Solution
Pull the CO2 injection nozzle forward.
Bayonet mount is in wrong position.
Pull the bayonet mount and nozzle towards you and attach
the bottle by turning one quarter anti-clockwise.
Water bottle is in wrong position.
Pull the water bottle towards you until it reaches its forward
position and release by turning one quarter clockwise.
✁ ✆ ☎ ✝ ✒ ✞ ✆ ✆ ✍ ☎ ✑ ☛ ✞ ✓ ☎ ✝ ✌ ✍ ✍ ☎ ✎ ☞
✑ ✍ ✍ ✆ ✄ ☎ ✏ ✁ ✆ ☎ ✝ ✒ ✞ ✆ ✆ ✍ ☎ ✏ ✑ ✆ ✄ ✏ ✁ ✆ ☎ ✝ ✞ ✂ ✍ ✖ ✛ ✟ ✆ ✞ ✆ ✄ ☎ ✌ ✍ ✍ ✍ ✑ ✂ ☎ ☞
CO2 bottle is running low.
Replace the CO2 bottle.
CO2 bottle is not screwed in tight enough.
Screw the CO2 bottle tightly into the device.
Water is too warm.
Use cold water as CO2 dissolves better in cold water.
CO2 bottle is not screwed in tight.
Remove the CO2 bottle and reattach it securely following
the instructions on page 28.
Replacement gasket needed.
See "replacing the CO2 gasket".