The Learning Feature; (How To Copy Functions From Your Original Working Remote Onto The One For All 4) - One for All URC-3740 Bedienungsanleitung

(How to copy functions from your original working remote
Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your ONE FOR ALL, nor your original remote control
is pointing at your device.
Example: To copy the "mono/stereo" function from your original TV
remote onto the "Red"key of your ONE FOR ALL 4.
1 Place both remote controls (the ONE FOR ALL 4 and your
original) on a flat surface. Make sure the ends which you
normally point at your device are facing each other. Keep
the remotes at a distance of 2 to 5 cm.
2
3
4
5
6
7
- Learning is mode specific. To access your learned function,
press the appropriate device key first.
- The ONE FOR ALL 4 can learn approximately 100 functions.
- You can replace a learned function by placing another learned
function on top.
- Upon changing the batteries, your learned functions will be retained.
WWW ONEFORALL COM

The Learning Feature

onto the ONE FOR ALL 4)
Press and hold down the MAGIC key
(for approximately 3 seconds) until the
red LED (underneath the TV key
in this example) blinks twice.
The red LED will blink once, then twice.
Press 9 7 5 (the red LED will blink twice).
Press the device key (on the ONE FOR ALL remote) to
select the mode to which you want to copy the learned
function (Example: TV key).
Press the key (on the ONE FOR ALL remote)
where you want to place the learned function
(Example: "Red" key). The red LED
(underneath the TV key in this example)
will flash rapidly.
Press and hold the key (on your original remote) that
you want to copy until the red LED blinks twice
(Example: "mono/stereo" key).
If you want to copy other functions within the same
mode, simply repeat steps 5 and 6 pressing the next key
you want to copy by learning.
To exit the learning mode, press and hold down
the MAGIC key until the red LED blinks twice.
x2
11