Accessories - Homcom C30-045V00 Bedienungsanleitung

EN

Accessories

① 1PC x Main frame
② 2PCS x Frame for wheels
③ 4PCS x Wheels
④ 2SETS x M10 Screw, washer and locknut set
⑤ 2PCS x Front adaptor with spring
⑥ 4PCS x Plastic clamping piece
⑦ 4PCS x M8 Screw
⑧ 2PCS x R pin
Assembly instructions
Step 1: Assemble the wheels on both sides of the frame and then Insert both pieces of
frames with wheels in to main frame.
Step 2: Screw M8 screws through the holes of plastic clamping pieces and frame, make
sure that the connecting part are covered with clamping pieces on both side. Then
use tools to tighten the screws on the frame.
Step 3: Insert adaptors on the top of the both frames with wheels, then locked with the R
pins.
Operation/Guide to using
1. Roll the stand and make sure your motorcycle front wheel is in the middle of the frame.
2. Rise the stand with circled handle and make the adaptors right positioned under the
bottom of both sides of motorcycle front forks.
3. With the adaptors securely supporting the bottom of motorcycle front fork, lower the
stand frame onto the ground.
Important
Always keep this stand away from children.
Check the stand is in good condition before using it.
Motorcycle Front Stand
2