Roborock Zeo X Bedienungsanleitung Seite 9

Installation
Installing the Rat Guard Panel
Installing the noise reduction pads (optional)
1. Find four noise reduction pads
on foam supporting board.
Removing the transit bolts
1. Carefully lay the washing machine
down on its rear side.
2. Carefully lay the washing machine down
on its rear side with leveling feet toward
the operator. Be careful not to break the
glass parts (control panel and door) of
the machine.
1. Unscrew the four transit bolts by
turning them counterclockwise
using a wrench (which is attached
in the foam supporting board).
2. Align the holes on the washing machine and on the rat guard
panel. Then tighten the screws to install the panel in place.
2
1
3
4
3. Remove the double-sided adhesive
protective film from noise reduction pads
and then paste pads around the bottom
of machine (two longer pads in spot 1 and
3, two shorter pads in spot 2 and 4).
2. Pull out the bolts and keep
them properly (for use
during transportation).
010
4. Finally set the machine
upright again.
3. Cover the transit bolt holes
with transit bolt covers.