LANCOM GS-2326+ Installationsanleitung Seite 34

Command Line Interface via network
If you know the IP address of the managed switch (see section above) and
the device is accessible from your computer via the network, you can use
the command line interface via the network.
A To do this, start a console such as SSH or Telnet and enter the device's
IP address as the target.
A Log on with user name and password (default: admin, password:
admin).
Command Line Interface via serial connection
If you do not know the IP address of the managed switch, you can use the
command line interface via a serial connection.
A Use the serial configuration cable to connect the LANCOM switch
to the configuration computer (see "Mounting and connecting the
LANCOM Switch").
A Start a terminal program on the configuration computer, such as PuTTY.
Use the following parameters for the connection:
A Baud rate: 115200
A Stop bits: 1
A Data bits: 8
A Parity: N
A Flow control: none
A Log on with user name and password (default: admin, password:
admin).
LANCOM Installation Guide Switches – Configuration
35