Karaoke Functions - Singing Machine SML283BK Bedienungsanleitung

OPERATION
3. Press the PLAY button after you've completed programming and you are ready to program playback. Press the
STOP button twice to clear all the programmed entries.
DISCO LIGHT OPERATION
To illuminate the Disco light, press the Disco Light ON/OFF button to switch it ON. Press it again to switch it off.

KARAOKE FUNCTIONS

Sing along with the music by plugging the provided microphone into either one of the microphone jacks on the
unit.
WARNING: Tapping or dropping the microphone can permanently damage your microphone. Resist the urge to
swing the microphone around by the cord.
MIC VOLUME
Adjust the MIC VOLUME control to a desired level to obtain the best performance.
WARNING: To avoid microphone feedback, do not hold the microphone too close to the speakers.
ECHO
Adjust the ECHO control to enhance the singers' voice for a concert hall effect.
AUTO VOICE CONTROL (MULTIPLEX DISCS ONLY)
Allows you to replace the lead singer's voice with your own when playing a multiplex recording. The vocals on
the multiplex recording will be muted when using the microphone. When the microphone is not in use, the pre-
recorded vocals will resume on a multiplex disc. The Auto Voice Control can be activated by pressing the A.V.C.
ON/OFF button.
BALANCE
Allows you to eliminate the lead singers' voice by rotating the knob to the left when playing a multiplex recording
or eliminate the music when rotating the knob to the right.
NOTE: When playing an audio CD or music only recording, the balance knob will shift the recording to the right
or left speaker.
REPEAT
To repeat the track currently playing, press the REPEAT button
once; the REPEAT LED will flash. To repeat all tracks, press the
REPEAT button twice; the REPEAT LED will light up and stay lit.
Press the PLAY/PAUSE button to begin.
To clear the repeat function, press the REPEAT button again;
the REPEAT LED will turn off.
PROGRAM
Use the PROGRAM button to program and play songs in a pre-
selected order.
1. Programming should be done in the Stop mode only. Press
the PROGRAM button until the PROGRAM LED flashes; the
track will read "0". Then press the SKIP buttons to select a
desired track.
2. Press the PROGRAM button to confirm the entry. You can
repeat the same steps up to a maximum of 20 tracks.
E-6