Karaca CAYSEVER ROBOTEA Bedienungsanleitung Und Garantie Seite 8

• Place the kettle on the power unit
base.
• Open the lid of the teapot, remove
the tea strainer, and after adding
enough tea, wash it with cold water
and place it in the teapot. The
maximum amount is about 60g/10
teaspoons, which is the amount
that the strainer can fill after the
tea leaves have absorbed the water.
• A smaller amount of tea can be
added depending on the desired
tea flavor and amount of tea. If
desired, tea bags can be used.
• Close the infuser reservoir lid,
and the boiling water transfer
mechanism will start operating.
If the lid is not closed well, the boiling water will not go to the air, but the tea
will not be ready as it will not go to the teapot either
• Place the kettle and teapot properly so that water vapor does not go to the
air and onto the body of the appliance.
• Depending on the amount of water put into the kettle, the water will boil
for 3-8 minutes, it will give an audible warning "The water boils and I now
brew tea with it".
• Then the "keep warm" function will be activated automatically to keep the
water at the boiling point by reducing the heating power. Meanwhile, the
water in the brewing water reservoir will start to be transferred to the
teapot.
• After all the water has been transferred to the teapot, this smart device will
automatically stop heating the brewing water reservoir.
• After 15 minutes, your device will give an audible "I brewed the tea, enjoy!"
warning indicating that the tea is ready, and the freshness indicator
will turn on a green light. The freshness light will turn red after 60 minutes.
This light defines that the tea has become stale.