Water Filling; Brewing Tea - Karaca Caysever Robotea Bedienungsanleitung Und Garantie

USING YOUR DEVICE
• Before using for the first time, wash your tea machine by filling it with
water. Boil the water in the kettle 2-3 times and change the water after
each boiling. While doing this, pour the water inside the device at the
maximum level and rinse the inside of the device with cold water.
NOTE: After boiling the water, make sure that the water boils according to
its hardness. It is extremely normal for powdery deposits
to form in hot water after each boiling process and it
does not have any negative effect on human health.

WATER FILLING

• When filling your device with water, ALWAYS use the
device by removing it from the power unit in order to
prevent water from splashing into the power unit.
• Do not add more water than the maximum level
specified in the kettle and brewing water tank and
less than the minimum level.
• Always Fill with water between
min. (0,5 Lt) or max.
(1.5 Lt) levels.
• Trying to boil the water below
the minimum level, the device to
turn off the device, or to try to
boil the water above the
maximum level may cause the
water to overflow.
• When pouring Water into the
brewing water reservoir, pour carefully and slowly
without splashing.
• There is a small hole to prevent splashing water on the
main body and prevent electric shocks that may occur.

BREWING TEA

• Connect the plug of your device to a grounded socket.
When you are not using your device, there is no harm
in having the plug in the socket.
• Fill the kettle between the minimum and maximum
levels. Also, according to the amount of tea you want to brew, fill the brewing
water reservoir with room temperature water. There are ¼, ½, ¾ and max
levels in the brewing water reservoir body, which show the pot capacity.