Failure Display - Asko Td76 Gebrauchsanweisung

Problem/ Cause
Error
A slight hitting If the dryer is out of use for a
noise appears. long period of time, the same
points of load-bearing elements
or components are under stress
for a long time, causing
temporary deformation.
The door opens Excessive load on the door (too
during drying. much laundry in the drum).
Unevenly dried Laundry of varying types and
laundry. thickness, and excessive
amount of laundry.
Laundry not dried Filters are not clean.
or drying takes
too long.
Dryer is placed in a closed
room; room that is too cold; or
room that is too small and the
air overheats as a result.
Laundry was not sufficiently
wrung or spun.
Amount of laundry dried in the
appliance is too large or
insufficient.
Laundry (such as bedding) gets
tangled into large balls.

Failure display

In case of a failure while a programme is underway, Error (Error) X is indicated on the display. Press
and hold the Ok button (Ok) to display the error description on the display. Switch off the dryer and
turn it back on.
Errors: what to do?
What to do?
The noise will subside without any intervention.
Reduce the amount of laundry.
Make sure you have sorted the laundry by
type and thickness, whether you have added
a suitable amount of laundry to the drum, and
whether you have selected a suitable program.
Clean the filters (see chapter Cleaning and
maintenance).
Make sure there is adequate supply of fresh
air to the dryer; for example, open the door
and/or window.
Check if the temperature in the room where
the dryer is installed is too high or too low.
If the load is still wet after completed drying
cycle, an appropriate drying program should
be run again (after cleaning filters).
Use a suitable program or extra functions.
Close the buttons or zippers on the laundry
before drying. Select a suitable programme
(e.g. the Bed linen programme).After the
drying process, loosen the laundry and select
an additional drying programme(e.g. Timed
drying).
57