Cleaning The Filter - Solac Blast Style Essential Gebrauchsanleitung

LEFT AND RIGHT STYLER BARRELS
• These attachments are designed to make curls
automatically and easily. Each attachment has a different
direction of wind for the left and right side of the head.
• Place the appliance upside down.
• Take a strand of hair and bring it close to the accessory.
The accessory will attract the strand thanks to the
Coanda effect and curl around the barrel.
• Leave it still for a few seconds and fix the curl with the
cool shot function.
• Turn the appliance off and slide down the styler barrel.
• Repeat the steps with the rest of the hair.
ONCE YOU HAVE FINISHED USING THE APPLIANCE
• Turn the appliance off by using the ON/OFF switch.
• Unplug the appliance from the mains.
• Allow to cool down.
• Clean the appliance.
SAFETY THERMAL PROTECTOR
• The appliance has a safety device, which protects the
appliance from overheating.
• When the appliance switches itself on and off repeatedly,
for reasons other than the thermostat control, check to
ensure that there are no obstacles that impede correct air
entry or expulsion.
• If the appliance turns itself off and does not switch itself
on again, disconnect it from the mains supply, and wait
for approximately 15 minutes before reconnecting. If the
machine does not start again seek authorised technical
assistance.
CLEANING
• Disconnect the appliance from the mains and allow it to
cool before undertaking any cleaning task.
• Clean the equipment with a damp cloth with a few drops
of washing-up liquid and then dry.
• Do not use solvents, or products with an acid or base pH
such as bleach, or abrasive products, for cleaning the
appliance.
• Do not let water or any other liquid get into the air vents to
avoid damage to the inner parts of the appliance.
• Never immerse the appliance in water or any other liquid
or place it under running water.

CLEANING THE FILTER

• The air inlet filter should be cleaned periodically for proper
operation of the device.
• To do this, pull down the magnetic filter cover.
• Clean the filter and remove any dirt or hair.
• Put the filter cover back in its place.