Shademaker Sirius Montage- Und Bedienungsanleitung Seite 9

Closing:
• Pull locking-pin and turn 90° in vertical position.
• H) Turn crank counter clockwise until the shade roof is closed. Slider car will move
downwards at the same time.
• Turn locking-pin in horizontal position to engage the slider car in the lowest positi-
on (A). Pull main support arm to the mast until locking-pin is engaged in the hole.
• Closed shade roof lie against the mast (A).
• Avoid clamping, abrasion and premature wear and tear of fabric. Pull out the fabric
individually and completely between the ribs, apply the layers tight around the pole
and secure with the strap. The fabric should not flap in the wind.
• Use the protective cover to protect your fabric and prolong the life of the canopy.
Maintenance and care:
• Inspect the installation fitting on a regular basis and tighten if necessary.
• Mast and frame can be washed with clear water periodically, if installation is in a
salty or industrial environment.
• Lubricate the inside rail of mast (5) and roller of slider car (18) as needed (eg. a
silicon spray, WD40) to enhance the ease of operation.
Canopy
• For general maintenance, use a soft brush to remove dust and dry soil. Wash
down with clean, warm water (i.e. garden hose) every so often to avoid dirt beco-
ming engrained. Allow the fabric to air dry before closing the canopy.
• If a thorough cleaning is necessary, sponge over the fabric using a mild soap so-
lution or detergent (pH value 7). Rinse well with plenty of water to remove all soap
residues.
• Never use detergents, cleaning fluids or solvents. Grease and oil stains may be
removed by using turpentine or similar with an absorbent cloth.
• We recommend giving the canopy a good cleaning on a more frequent basis if
installed in a location where the canopy is likely to become soiled.
• The cover should never be rolled up for long periods of time when wet or damp.
• Use of protective cover extends the fabric's lifetime and slows down the fading
process.