Grundig RR 1000 Bedienungsanleitung Seite 7

Operating Instructions
o Telescopic Aerial
Extendable aerial for VHF (FM) and SW (KW) capable of being
rotated and tilted.
@ FM Stereo Indicator
Lights up when a VHF stereo broadcast is received, provided
the switch @ is in the STEREO or SUPER STEREO position.
Record Indicator/Battery Check
Lights up when the record button @ is pressed.
— Flashes when batteries are low (set remains fully functional).
— Goes out when batteries are exhausted (the complete setof
batteries must be changed).
@ Tuning Scale
o Stereo Headphone
Socket
With the 3.5 mm headphone
loudspeakers are switched
0 MONO-STEREO Switch
With SUPER STEREO setting for artificially producing
pronounced stereo effect.
o Tape Type Switch
Cr for chrome dioxide tapes (IEC Type II).
Fe for ferric (iron oxide) tapes (IEC Type I).
CASS/RADIO Switch
o Waveband Switch
87.5-
VHF
SW/KW: Shortwave 5.9-
MW: Mediumwave 520-
145-
LW: Longwave
O Tuning Control
@)Tape Position Counter
With reset button (O-Set).
Cassette Compartment
Open with STOP/CASSbutton@; close by hand.
@ Volume Control (Left Channel)
@ Volume Control (Right Channel)
@ Tone Control
@ Record (REC.) Button
Press to starttape for recording (STARTbutton@automatically
engages when this is done).
START Button
Press to stan tape for playback.
O Fast Rewind Button (4 4)
Press to rewind tape rapidly.
@ Fast Forward-Wind Button
Press to wind tape forward rapidly.
jack plug inserted, the built-in
off.
a more
108MHz
18MHz
1620 kHz
280 kHz
(YY)
@ STOP/CASS Button
Press to cancel tape functions initiated with buttons O, O, @
and @
Pressing this button a second time opens the cassette com-
partment @
o PAUSE Button
Press to make short pauses during recording and playback.
Restart the tape by pressing the PAUSE button a second time.
@ Mains Socket
For 220V, 50/60 Hz AC supply voltage (GB: 240V, 50 Hz).
@ Universal Socket
Input for connecting microphones or other sound sources (eg :
record deck with crystal or ceramic cartridge, or tape/cassette
recorder) to make recordings.
Output for playing back through an amplifierorfor
a second tape/cassette recorder.
Warnjng: In making copies of broadcasts, records, cassettes
etc. care sfould be taken not to infringe the third party rights
valid in the country concerned.
@ Oscillator Switch
(3 positions)
If whistle is heard when recording mediumwave or longwave
stations, set this switch to another
@ Loudspeaker Sockets
For connecting two extension
channels) with 3.5 mm jack plugs.
@ Battery Compartment
copying with
position.
loudspeakers (left and right
7