Mounting Position - Moes Wls-Td-Rgb Benutzerhandbuch

Warnings
The light source of this luminaire is not replaceable. When the light source
•
reaches the end of its life, the entire luminaire must be replaced.
For indoor use only.
•
Children should be prevented from accessing electrical appliances.
•
Do not connect the rope light to the power supply while it is still in the packaging
•
or wound onto a reel.
Do not operate the product unless the LED strip is fully unrolled.
•
Do not use the rope light when covered.
•
Do not open or cut the rope light.
•
Do not switch it on before complete installation.
•
The manufacturer assumes no liability for damages caused by non-compliance
•
with the safety and installation instructions.

Mounting Position

This product is suitable for decorating indoor areas such as hallways or living
•
rooms.
The strip should be stuck on a clean, dry, and smooth surface.
•
Stick the double sided tape to the back
of the connector
Connect the DC connector, power the adaptor
Press the reset button
Remove the paper cover and attach
to the wall
5