Mooer Micro-Serie Bedienungsanleitung

MCJOGR
7"étte
Distortion
O
Owner's
Precautions
PLEASE READ CAREFULLY
Power Supply
Please connect the designated AC adapter
Please be sure to use only an AC adapter
minus _The maximum working voltage
dangerous equipment damage, fire or other problems
Unplug the AC power adapter when not using or during electrical
Connections
Always turn off the power of this and all other equipment
disconnecting, this will help prevent malfunction
Also make sure to disconnect all connection
moving this unit
Cleaning
Clean only with a soft, dry cloth If necessary,
DO not use abrasive cleanser, cleaning
cleaning fluids, or chemical-impregnated
Interference with other electrical
Radios and televisions placed nearby may experience
Operate this unit at a suitable distance
Location
To avoid deformation, discoloration,
this unit to the following conditions:
• Direct sunlight
• Magnetic fields
• Excessive dusty or dirty location
• Strong vibrations or shocks
FCC certification
This device complies with Part 15 of the FCC Rules
to the following two conditions:
• This device may not cause harmful
• This device must accept any interference
that may cause undesired operation
Main
• Ultrawide dynamic range and extraordinary
• 2 Working Modes: HP/LP
• Full metal shell
• Very small and compact design
me
Pedal
Manual
BEFORE PROCEEDING
to an AC outlet of the correct voltage
which supplies 9V DC, center
shall not exceed 12 V, Otherwise
storms.
before connecting
and / or damage to other devices
cables and the power cord before
slightly moisten the cloth
alcohol, paint thinners, wax, solvents,
wiping cloths
devices
reception interference
from radios and televisions.
or other serious damage, do not expose
• Heat sources
• Extreme temperature or humidity
• High humidity or moisture
Operation is subject
interference.
received, including interference
Features
open tube-like drive sound
• True bypass switch
• DC 9V adapter power supply
HP: High peak mode, boost up the bottom-end,
Drive knob, you will get more volume and a slight increase in high-mid range
(around 3.5KHz)
LP: Low peak mode, color up extreme little to the original sound, very nice for
clean boosting
VOLUME
may be
or
7. VOLUME
8. TONE Knob: Adjusts the tone color of the drive sound
9. DRIVE Knob: Adjusts the gain of the drive sound
Effects Modes: 2 (HP, LP)
Input: 1/4" monaural jack (impedance: 470k Ohms)
Output: 1/4" monaural jack (impedance: 1k Ohms)
Power Requirements:
recommended
Current Draw:
Dimensions:
Weight: 150g
Accessories:
Effects Explanation
Panel Instruction
1. TRUE
Push down the footswitch to toggle
DC
between on and bypass status
2. ONIOFF
Shows
TONE
Hustle Drive, when the LED
is lit the effect is engaged
3. DC IN Power
For power supply, use a 9-volt
DC regulated AC adapter (plug
polarity is positive on the barrel
DRIVE
and negative in the center)
4. INPUT
1/4" mono audio jack, for
connecting
5. OUTPUT
1/4" mono audio jack, outputs
the signal
6. Mode
Switch
MOOGR
LP mode
Knob: Adjusts the volume of the drive sound
Specification
AC adapter 9V DC (center
to use Mooer Micro Power
6 mA
93 5mm (D) x 42mm (W) x 52mm (H)
Owner's Manual
when increasing distortion by
BYPASS Footswitch:
LED:
the on/off status of
Jack:
Jack:
guitar.
Jack:
Switch:
between HP mode and
minus plug),
Part No: 2030501696