Cabletech UCH0151 Bedienungsanleitung Seite 5

1. Mount on Solid
W-A
W-B
• When installing wall mounts on cinder block, verify the actual concrete thickness is at least
1-3/8" (35mm) for using the concrete anchors. Do not drill into mortar joints! Be sure to
mount in a solid part of the block, generally 1" (25mm) minimum from the side of the block.
It is suggested electric
to avoid breaking out the back of the hole when entering
• Installers must verify that the supporting surface will safely support the combined load of the
equipment and all attached
User
Brick and Concrete
A WARNING
drill on slow setting
hardware and components.
manual
Block
is used to drill the hole instead
a void or cavity.
60mm
2.4'
10m
ø 3/8")
Mark the
exact location
mounting
Drill pilot holes
Screw the wall
plate onto
the wall
of a hammer
of
holes
drill