Instructions For Use; Scope Of Delivery; Installation Location / Commissioning; Select Type Of Cut - Genie Rc 08 Plus Bedienungsanleitung

Instructions for use

Please read these operating instructions before using the device. Keep these operating
instructions for future reference. Hand over all documents when passing the product on to
third parties.
• Protect the product from direct sunlight, naked flames, heat sources, moisture, humidity and dust.
• The product is not intended for commercial use.
• The product may only be used indoors.
• Empty the collection container at regular intervals, otherwise it may result in a paper jam.

Scope of delivery

Check the contents of the packaging. If something is missing or damaged, please contact our service.
1 Rotary Trimmer RC08 Plus

Installation location / Commissioning

Place the product on a stable, flat surface.

Select type of cut

1 Lift up the cover at the cutting head.
2 Select the desired cutting mode by turning the roller switch on the cutting head.
3 There are the cutting types Straight, Perforation, Wave, and Fold available.
4 Fold the cover back down.

Cutting

1 Move the cutting head to the outer end of the guide rail.
2
Slide the paper to be cut under the transparent plastic rail.
3 Position the paper to be cut using the markings as a guide.
4 Press the transparent plastic rail down so that the paper to be cut does not slip.
5
Move the cutting head along the guide rail with gentle pressure.

Blade change

1 Remove the cover at the end of the guide rail on the left side.
2 Push the guide rail through the opening out of the device.
Caution! Risk of cuts from sharp blades! Do not touch under the cutting head.
3
Pull the cutting head off the guide rail.
4 Remove the blade from the cutting head and insert a new blade.
5 Push the cutting head back onto the guide rail.
6 Push the guide rail back into the device.
7 Reinstall the cover.
1 Operating instructions
6